This is an ESP32 fork of Tempests TCode sketch (repository doesnt exists yet). It adds Network Tcode capabilities and WiFi/BLE configuration.
See the pdf in the latest release zip https://github.com/jcfain/TCodeESP32/releases
First You need to install the dev environment for the ESP32 and arduino. Some good placees to start
- https://platformio.org/install/ide?install=vscode
- https://docs.platformio.org/en/latest//integration/ide/vscode.html#quick-start
- https://github.com/espressif/arduino-esp32#installation-instructions
You will need a few additional libraries to build this sketch.
If platformIO is installed, it should download these automatically on first build.
- ESP32Servo
- ESP Async Webserver
- EAsyncTCP
- ArduinoJson
- paulstoffregen/OneWire@^2.3.5
- milesburton/DallasTemperature@^3.9.1
- adafruit/Adafruit SSD1306@^2.4.3
- Adafruit GFX Library
- Adafruit BusIO
- SPI
I used Visual studio code and PlatformIO for this project.
I believe the sketch could be built in the Arduino IDE with the correct libraries but I have not tested.
Modify /data/userSettingsDefault.json with your wifi ssid and password etc.
Flash the code and upload the filesystem image. Then start the monitor on the COM port to see the ip address if dynamic.
You can also set the wifi settings via the web interface in AP mode on first boot.
Or you can use the Android configurator app I wrote found here:
https://www.patreon.com/posts/tcode-android-51962566