BUG: Main Button, E-Brake and throttle became unresponsive
Closed this issue · 2 comments
Scooterhacking Tool
Firmware (SHFW)
Type of issue
Other
Severity of issue
medium (affects usability but has a workaround)
SHUT Version
SHUT 2.6.1
SHFW Version
SHFW 3.9.1
Scooter model
Ninebot G2
Description of the Bug
After riding the scooter with the settings mentioned in step to reproduce, most of the scooter "headset" became unresponsive.
Steps to Reproduce
Settings I used -- G2 SHFW guide by KingBro
!!Enable Expert view in the top right corner of the Config!!
Throttle
• Set a 25A DPC Curve.
• 100% acceleration boost.
• Overmodulation ON
Brake
• Set a 55A Curve.
• Set Brake boost between 20-60% depending on your weight.
Field Weakening
• Start speed: 20kmh
• Initial field current: 0A
• Variable field current: 2000mA/km/h
• Iq: 75A
• Id: 45A
Motor settings
Wheel size: 9.7 inches for accurate dash speed
I was riding for 1-2 kilometers, then while waiting on a traffic light
I wanted to accelerate -> nothing happend
I wanted to reboot scooter -> main button didnt work
E-Brake also didn't work
Workaournd:
- Wait for the scooter to turn itself of
- And boot it again
Turn Signal and E-Horn did work tho.
Expected vs. Actual Behavior
Expected:
- Scooter shall work as expected
Actual Behavior:
- I wanted to accelerate -> nothing happend
- I wanted to reboot scooter -> main button didnt work
- E-Brake also didn't work
Contact Information
tastytom - Discord
Edit:
I found out why, it went into to locked mode as I played with different settings, probably far fingered.
I experienced now the same with the locking functionality of SHUt
Is caused by locking the scooter, will open another issue.