Xbox not see rpi pico bios install on older version
Closed this issue · 11 comments
Can you update install guide for older version 1.0 to 1.5 with pic if posible .
I have Xbox OG 1.1( have more Xbox OG rev ) on witch i installed 2 pico zeros to test and not load Cerber bios logo just default bios animation.
If need info instaled and no HDD, DVD instaled when testing.
Lifting bios leg on board is needed only for rev 1.6/1.6b ?
Thanks for support
you need to get Lframe from the mpcx, https://xboxdevwiki.net/LPC_Debug_Port
do you wire the Lframe from mpcx or just d0 to gnd?
consoles 1.0 - 1.2 only D0 to gnd.
consoles 1.3 - 1.5 D0 to gnd, and mpcx.
1.6 consoles rebuild LPC and lift Xyclops chip pin.
i have done one console rev 1.3 by date with ?? on wiki, needed Lframe from MPCX to work. On console info show rev 1.2. D0 to GND.
do you wire the Lframe from mpcx or just d0 to gnd?
It was rev 1.1 not needed.
i found out in the morning D0 to GND :-), been tiered and missed. Found out that black rpi pico not working, picture below. do not buy this RPI PICO for modchip
Classic model works as should, new revisons of rpi pico not working.
That version is working for me,
but i tested other black models and a green clone that doesnt have any raspberry logos to no work.
Which size number your resistors are?
i found out in the morning D0 to GND :-), been tiered and missed. Found out that black rpi pico not working, picture below. do not buy this RPI PICO for modchip
Classic model works as should, new revisons of rpi pico not working.That version is working for me, but i tested other black models and a green clone that doesnt have any raspberry logos to no work.
Which size number your resistors are?
its 0805 size (2mm x 1.25mm)i had
only them
Hah, I had two questions that were both answered here:
- is this compatible with boards other than the v1.6?
- Does the v1.6 require LPC rebuild?
Thanks for clearing this up by asking the same questions I had.
Hah, I had two questions that were both answered here:
- is this compatible with boards other than the v1.6?
- Does the v1.6 require LPC rebuild?
Thanks for clearing this up by asking the same questions I had.
- Yes i have done on 1.1 and 1.3
- You need to rebuild and D0 and MPCX as with other chips.
all solved