Support on version 1.0
Closed this issue · 8 comments
Hi,
following Tito's video I tried to use this mod on a version 1.0 motherboard, using an original Pico and Pico W.
None of the ROM's I tried worked, (even the one extracted from my Alladin modchip) and the interesting thing is that if I use one of the original release xbox bios, it starts to boot loop
In none of these instances I got any video output from the system.
I tried using the source code compiled locally as well as the 0.2Beta release.
Am willing to try and experiment with everything you deem necessary ;)
Thanks for a great project!
Have you checked all solder joints
Have you got D0 grounded or connected to the ModXo?
Cheers
D0 is connected to modxo and all solder joints were verified multiple times
but later today I'll recheck it again
Let me check with 120 Ohm resistors.
as a side note, I found out that the waveshare pico was a bit warmer to the touch then the original (it may mean nothing at all)
I Still haven't found anything. I am configuring a debugger so i can find out more.
This hasn't worked for me and I've now lost interest in it.
Will keep an eye on the project but will close this issue.
Good luck with further development.
Just adding that it's working on a 1.0 over here but the video is glitched while using a components cable, it's fine using a normal composite one.