XCP Basic Driver Using PcanViewer Interface
Opened this issue · 0 comments
Trifi883 commented
Hello Michael ,
I would like to use XCP BASIC Driver to make some measurement , the Hardware that i had is Pcan and and IC5700 ,
the software : Winidea , pcanviewer ,
As first step , the connection and other commands work perfectly when i send it in the Pcan viewer , but when i want to configure the DAQ "Dynamic Configuration" i found a problem in the phase of Start_stop_synch DD 01 ,
i use a standrad CAN Not CAN FD .
please can you give me some advices ?
Best Regards ,
Bechir .