sinara-hw/Almazny

missing mounting HW

Closed this issue · 4 comments

gkasprow commented

@shanasz please add to the BOM

  • mounting screws + washers + standoffs (copy if from Stabilizer mezzanine)
  • SMP bullets
jordens commented

IME the screw heads on the mirny underside are thicker than allowed and interfere with the adjacent panel's gasket. Same on stabilizer/pounder. Is there something we can do?

gkasprow commented

flat head screws should do the job
obraz

jordens commented

You had some really nice soldered or press-fit standoffs or screws on dio-mcx IIRC. Those would be great.

gkasprow commented

yes, but here I need nontypical height. These inserts are available only in 1mm increments
I used such in the Thermostat EEM design. DIO_MCX has classical ones since non-typical height was needed as well.

  • 👍1