Paper corresponding to the code
Onepersonformsaarmy opened this issue · 4 comments
Hello, I am going to use your code to calculate the IEEE123 power flow, and generate the network topology through the voltage of each node. I hope to quote your paper, but I can't find it. Can you share an address? Thanks a lot.
Also, where did you get this active power data?
Hello, I am going to use your code to calculate the IEEE123 power flow, and generate the network topology through the voltage of each node. I hope to quote your paper, but I can't find it. Can you share an address? Thanks a lot.
Hello, I am going to use your code to calculate the IEEE123 power flow, and generate the network topology through the voltage of each node. I hope to quote your paper, but I can't find it. Can you share an address? Thanks a lot.
hello, Did you manage to simulate the program without any problem. I had a problem while running COM interface for OpenDSS
Hello, I am going to use your code to calculate the IEEE123 power flow, and generate the network topology through the voltage of each node. I hope to quote your paper, but I can't find it. Can you share an address? Thanks a lot.
Hello, I am going to use your code to calculate the IEEE123 power flow, and generate the network topology through the voltage of each node. I hope to quote your paper, but I can't find it. Can you share an address? Thanks a lot.
hello, Did you manage to simulate the program without any problem. I had a problem while running COM interface for OpenDSS
Yes, I successfully run the COM interface in matlab. However, when calculating the IEEE123 node power flow, the load of the node cannot be changed. I modified this.
Please cite this paper: "O. Ardakanian et al., "On Identification of Distribution Grids," in IEEE Transactions on Control of Network Systems, vol. 6, no. 3, pp. 950-960, Sept. 2019, doi: 10.1109/TCNS.2019.2891002."