Make a Jumper Wire vitamin library
Axford opened this issue · 3 comments
Will likely share parts with Jamie's Arduino vitamin (e.g. header model), so these could later be split out into a shared library.
will incorporate the ribbonCable utility to generate the cable (bezier curved no less)
should support:
- diff end types (e.g. male, female)
- diff number of pins
- diff cable colours
Need to think about how attachments will work - should each end be attachable separately? that would be good from an assembly guide PoV, but may be difficult to integrate into the modelling semantics....
That'd be cool - and I was thinking to split out the header (and maybe the pins themselves) into seperate libraries.
Jamie
On 25 Oct 2014, at 21:50, Axford notifications@github.com wrote:
Will likely share parts with Jamie's Arduino vitamin (e.g. header model), so these could later be split out into a shared library.
will incorporate the ribbonCable utility to generate the cable (bezier curved no less)
should support:
diff end types (e.g. male, female)
diff number of pins
diff cable colours
Need to think about how attachments will work - should each end be attachable separately? that would be good from an assembly guide PoV, but may be difficult to integrate into the modelling semantics....—
Reply to this email directly or view it on GitHub.
draft vitamin is in the jumperWire branch - wrapper is sandbox/JumperWireDev.scad
got the basics working :)
Complete - merged into master