Tabs and Retract to clearance
Opened this issue · 6 comments
Hello,
Everytime I add tabs to the design I want to cut the generated gcode keeps sending the Z axis to the clearance level before moving it to the next pass depth.
Is there any way to change that ?
It normally doesn't do that. Can you post a test case? Save Settings -> Gist then post the link here.
Here are the settings but I dont think it has to do with that
https://gist.github.com/anonymous/a321e9139d5f67a075ad23ff09197220
You saved before you loaded an SVG and added your operations and tabs. If you save after you do all that I'll get a complete reproduction. Make sure you're OK sharing your SVG before doing this.
Sorry. I saved it again with an svg loaded.
https://gist.github.com/anonymous/43ce313738bf094d80e7e93288932f8a
Very odd. That issue appears to be tied to the shape.
The same bug happens with all shapes. Even a simple circle or square.
Try make a simple square, add tabs and you will see your own.
On Sat, Aug 6, 2016 at 6:26 PM, Todd Fleming notifications@github.com
wrote:
Very odd. That issue appears to be tied to the shape.
—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub
#51 (comment), or mute
the thread
https://github.com/notifications/unsubscribe-auth/AFvq7nDn04XKVTHyM3xB7sOcVLcRlssAks5qdKeRgaJpZM4JdebI
.