thijsbekke/OctoPrint-Pushover

Sends notification of first few layers complete after running a run off line

Syco54645 opened this issue · 2 comments

Not sure what you want to call the line the printer draws at the start of a print. I have mine set to do a little purge on the left side. After it does this the plugin sends a notification that the first few layers are complete. Is there a way to account for this line?

Hi,

The line around your print is called the brim. Does your z-axis move when it does the purge on the left side ?

At least I did increase the value when to send the "first couple of layers are done" notification.

ff5976d

It will be there with an update real soon

This was the purge line that caused it to say the first few layers were done.

I actually disabled the plugin as I was getting several entries a second in the error log and it was causing a stalling when doing circles. I posted my log on reddit when I was having stalling issues, perhaps it will shine some light on the issue I was having.

https://www.reddit.com/r/octoprint/comments/g9oenz/any_solution_to_stutters_ender_3_with_abl_running/