PINDA v2 BTT002 v1.0
KI5QMT opened this issue · 6 comments
Did you test the latest prusa-aio-bugfix-2.1.x
code?
Yes, and the problem still exists.
Bug Description
BTT002 v1.0 Prusa Bear Pinda 4 pins will not detect and ends up crashing the nozzle into the bed ive tried everything including other pindas but the board wont detect them the pinda lights up but wont trigger the firmware.
Bug Timeline
No response
Expected behavior
No response
Actual behavior
No response
Steps to Reproduce
No response
Version of PrusaAIO Firmware
AIO v2.1x
Electronics
BTT002 V1.0
Add-ons
No response
Bed Leveling
ABL Bilinear mesh
Your Slicer
PrusaSlicer
Host Software
Pronterface
Don't forget to include
- A ZIP file containing your
Prusa_AIO_Configuration.h
.
Additional information & file uploads
Did you cut the diag pin on your Z driver? The PINDA won’t work with it attached.
Both the PINDA V2 and SuperPINDA work fine on the BTT002 boards here.
Did you cut the diag pin on your Z driver? The PINDA won’t work with it attached.
Both the PINDA V2 and SuperPINDA work fine on the BTT002 boards here.
do I need to cut diag on both tmc2209 z drivers
do I need to cut diag on both tmc2209 z drivers
The BTT002 only has a single Z driver. Are you sure you have a BTT002 motherboard?
The two drivers that need diag pins cut when used on the BTT002 are Z and E.
I think I was confusing another driver that was the E I've Been working on this since 6 am my brain is moosh lol
I will have to cut those pins or desolder them once I rewire my case
I've added some additional warnings during compile time about diag pins/jumpers and updated the Motherboards & Wiring Guide in the wiki with similar comments.