Videos
Opened this issue · 0 comments
Not really a issue, but as a newbie. I was hoping you could make a video on using the spoilboard surfacing and what each parameter represents.
Eg. Im assuming "X Extent" and "Y Extent" is the size of spoilboard i want surfaced?
"Surfacing stepover" im assuming is the overlap of the tool?
"Cutting direction" is which way you want the cuts to happen, N would be +Y to -Y, S would be -Y to +Y,E would be cutting +X to -X?, W would be -X to +X? is that correct?
Z Level clearance is how high Z when moving without cuts?
Z Height of cut is how low below Home Z0 to cut material? so eg. -0.5 would cut 0.5mm below Z0?
The feedrates and Perimeter I understand (as i seen the listed Perimeter video for this). just bit confused with the other parameters.
For example, if i wanted to surface a X1500 by Y3100 spoilboard from mdf for a lowrider V3 how would i do this?