viveris/jtag-boundary-scanner

Cannot find JLink device

Opened this issue · 7 comments

agieson commented

After updating drivers, moving the JLinkARM.dll (and JLink_x64.dll for good measure) into the JTAGBoundaryScanner folder (and Windows_x64 folder for good measure), the GUI was not able to find the JLink device. Any suggestions on how to proceed? The log did not show any information at all, so I'm stuck and not sure what to try next.

jfdelnero commented

"After updating drivers" Do you mean the JLink driver or something else ?

agieson commented

yes, updating the JLink driver

jfdelnero commented

And this was working before the driver update i suppose ?
Do you use the last software version ?

agieson commented

I have not been able to get the software working yet. Yes, I do have the latest release installed

jfdelnero commented

ok i will check the latest jlink driver support.

keck9939 commented

Assuming you are on 64 bit Windows, try copying JLink_x64.dll to the same location as JTAGBoundaryScanner.exe and then rename it JLinkARM.dll. JLinkARM.dll as supplied by JLink seems to be a 32 bit dll and so will not load into a 64 bit app. Doing this, my J-link probe showed up.