chinese clone handle compatibility
keiser1080 opened this issue · 2 comments
Hi,
is your aviator plug wiring compatible with the chinese handle?
It's a bit confusing.
for example + is pin 2 and - pin 5 & 4.
on the ksger clone & other i see + is pin 5 & ground pin 4.
as you can see here ksger
Hi,
I'm not sure if your picture is correct. I can't imagine that the tilt switch is connected to earth. However, there is no official standard. I'm using 4-pin handles from china, e.g. https://aliexpress.com/item/32925815648.html, https://aliexpress.com/item/33046441829.html, https://aliexpress.com/item/4000130747937.html, https://aliexpress.com/item/32891866988.html (all tested). If you already have a handle, you can use a multimeter to figure out the correct pinout and wire the aviator plug accordingly.
Hi,
I'm not sure if your picture is correct. I can't imagine that the tilt switch is connected to earth. However, there is no official standard. I'm using 4-pin handles from china, e.g. https://aliexpress.com/item/32925815648.html, https://aliexpress.com/item/33046441829.html, https://aliexpress.com/item/4000130747937.html, https://aliexpress.com/item/32891866988.html (all tested). If you already have a handle, you can use a multimeter to figure out the correct pinout and wire the aviator plug accordingly.
Yes i have a handel, i have buy the following station
The station come without the tips.
I tryied using my power cord the screen show error .
Then as soon as i recieved my tips from banggood i have tryed again.
My home fruse go down.
I tryed separatly the 24 power supply.
And the crontroler using my lab power supply then i see a blue smoke :) coming from a the controler.
I have checked the controler and i found 24v on the output of the regulator.
Conclusion the controler is totaly broken.
So i am planning to do your controller but with a esp32 in place of the atmega.
But i am still not sure what cause the problem.
I found a shortcut on the aviator plug between the pin labeled E & pin labeled G
And now i found the ntc on the handel is also broken (the heatsrink do not cover entierly & there is a suspicious mark)
My handel is connected like this:
pin 1 : red (first pin from right of the tip)
pin 2 : withe connected to ntc toward the pin 5
pin 3 : green (third pin from right of the tip)
pin 4 : blue connected to the mercury switch toward pin 3
pin 5 : black (second pin from right of the tip)
pin label on my solder station:
1:+
2:N
3:S
4:N
5:G
And the board and wiring are very similar to this one