[Q] (Your Question?)
Avatarsia opened this issue · 1 comments
Avatarsia commented
When i connect the X1 via Octoprint it Heats up a bit and then i get an M112.
Without any Feedback what's the issue, any special needs in Marlin to work with the TFT Firmware ?
wgcv commented
I don't think that is normal. I have my print connected all day to Octoprint and never happen to me. Is not recommended to have the TFT and octopine in the same time, you can set settings->disconnect because they use the same serial bus and can give error message (But not heats up and M112).