Shelly EM Not providing Monitoring Data Just Relay
Opened this issue · 2 comments
ebarretopr commented
Good Afternoon,
I have flashed a Shelly EM OTA, once it opened, I only have the On/Off control no power monitoring.
I have used the following templates with the option 21 enable on both without any luck, any help is appreciated.
{"NAME":"Shelly EM","GPIO":[0,0,288,0,32,0,0,0,640,3456,608,224,0,1],"FLAG":0,"BASE":18}
{"NAME":"Shelly EM","GPIO":[0,0,0,0,0,0,0,0,6,156,5,21,0],"FLAG":15,"BASE":18}
Thanks!
tobby88 commented
Disconnect power and reconnect. This should help.
hagenbuch commented
Yeah, I had the same issue with a Shelly 2.5 - turning off power and then after 10 seconds switching it on again sorted things out quite "automagically".