Y Attachments break when removeing belts
Opened this issue · 2 comments
skyne commented
I've installed them in reverse, when realized and tried to remove the belts to swap them, the middle part broke out (see pic.)
Additional info:
- probably I've installed the covers with longer screws than intended
- I've also had white (reinforced, stiff) belts installed, this could've also caused the "harder to remove" effect
zruncho3d commented
bstrawsma commented
I also modified this part when installing it on mine to have a through hole with a heat set insert on the back and then held in place with washers.