/PS4-esp32

Use a ps4 controller with an esp32

Primary LanguageC

PS4-esp32

Use a PS4 controller with an ESP32

This is heavily based on the work of Jeffery Pernis to connect a PS3 controller to an ESP32. You can find that here: https://github.com/jvpernis/esp32-ps3

Here's a video about how this library was made.

This repo can be downloaded as a zip file and imported into the Arduino IDE as a library.

Installation

The instructions on how to do this are base off what can be found here

The instructions below may no longer work. If they do not work for you, try applying changes from the various forks of this repo.

  1. You can add the ESP32 boards to your Arduino IDE by adding them to the Boards Manager:
    1. Open File -> Preferences
    2. Paste the following URL in the Additional Boards Manager URLs field: https://dl.espressif.com/dl/package_esp32_index.json
    3. Open the Boards Manager with Tools -> Board: "xxx" -> Boards Manager
    4. Look for esp32 (probably the last one in the list), and click install (version 1.0.3 works best)
    5. Select the ESP32 board you have with Tools -> Board: "xxx" under the section ESP32 Arduino
  2. To install this library into your Arduino IDE:
    1. Click on the "Code" button in the top right of this page
    2. Select "Download Zip" (It's always a good idea to look through the code on this page first to make sure you know what you're downloading)
    3. In the Arduino IDE, navigate to Sketch -> Include Library -> Add .ZIP Library, then select the file you just downloaded

Pairing the PS4 Controller:

When a PS4 controller is 'paired' to a PS4 console, it just means that it has stored the console's Bluetooth MAC address, which is the only device the controller will connect to. Usually, this pairing happens when you connect the controller to the PS4 console using a USB cable, and press the PS button. This initiates writing the console's MAC address to the controller.

Therefore, if you want to connect your PS4 controller to the ESP32, you either need to figure out what the Bluetooth MAC address of your PS4 console is and set the ESP32's address to it, or change the MAC address stored in the PS4 controller.

Whichever path you choose, you might want a tool to read and/or write the currently paired MAC address from the PS4 controller. You can try using sixaxispairer for this purpose.

If you opted to change the ESP32's MAC address, you'll need to include the ip address in the PS4.begin() function during within the setup() Arduino function like below where 1a:2b:3c:01:01:01 is the MAC address (note that MAC address must be unicast):

void setup()
{
    PS4.begin("1a:2b:3c:01:01:01");
    Serial.println("Ready.");
}