16n-faderbank/16n
Sixteen faders, a Teensy, MIDI over USB and jack, CV out, and I2C out. Phew.
C++NOASSERTION
Issues
- 3
Teensy 3.2 -> 4.0 Migration
#68 opened by janczmok1970 - 3
16n as sequencer
#65 opened by FantacciSimone - 3
Teensy 3.1/3.2 shortage (Design for Teensy 4.x?)
#67 opened by NeusAap - 0
v2.1.0 with LC not connecting to web editor
#66 opened by tonyjmorton - 0
Using 16n faderbank on VCV rack2
#64 opened by godzillalaughs - 1
- 2
Are 100mm faders possible?
#61 opened by mikattack - 6
faders not going to full value on midi
#26 opened by altitude909 - 1
- 0
CV outputs not 100% accurate
#59 opened by anemlife - 0
- 9
- 0
- 1
negative 5v
#53 opened by nemoy - 3
Fader 1 controlling all values
#46 opened by apossibleworld - 5
- 2
16N not recognized on Mac
#45 opened by matpap - 2
Fader curve issues.
#47 opened by kmtksk - 1
I want to design the perfect mate for the 16n
#49 opened by sapyatkuen - 0
- 3
Motorised Sliders - suggestion
#29 opened by deskofcraig - 2
Inconsistent midi experience
#44 opened by doodlewhale - 1
Solder troubleshooting
#48 opened by mlinton - 2
2.5 mm screws missing on BOM?
#43 opened by montoyamoraga - 2
v201 non-working + weird debug message
#40 opened by modularev - 2
Teensy troubles
#39 opened by ian-c121 - 3
Only send messages when values change
#38 opened by trentgill - 3
Slider resistance is absent in BOM
#37 opened by vafu - 4
Add inbound sysex message for USB options.
#33 opened by infovore - 1
Add inbound sysex message for TRS options.
#34 opened by infovore - 1
Add inbound sysex message for device options.
#35 opened by infovore - 1
- 1
Error when compiling windows 7
#28 opened by jondent808 - 2
- 3
Panel thickness?
#24 opened by cschol - 0
- 1
Firmware 1.32, channel 3 stops working
#23 opened by altitude909 - 3
ansible 12c address mismatch?
#19 opened by okyeron - 2
Put i2c address in config.h
#18 opened by okyeron - 3
Standoff height?
#7 opened by okyeron - 9
Flip device
#14 opened by Elberstein - 7
Multiple faderbanks on the same I2C bus
#16 opened by Elberstein - 1
Bug in panel DXFs
#10 opened by infovore - 3
- 9
Issue compiling on Windows
#9 opened by infovore - 8
I2C, slave mode: wrong address
#12 opened by Elberstein - 1
I2C, wrong address for ER-301
#13 opened by Elberstein - 3
Add version number to Eagle files?
#4 opened by okyeron - 1
Slide Pots - 10K?
#5 opened by okyeron