Object duplication
Closed this issue · 2 comments
Adriex commented
Hi! I was working with an object that needed 6 supports, so I placed 6 cilinders and then made 6 duplications of the object. This produced a BIG performance loss, at the point that I had to wait a solid minute when tried to rotate one of the duplicated objects.
Already checked that wasn´t the objects fault. Ended up duplicating the objects I needed and putting the supports one by one object.
In this second approach every time a cylindical support was placed, Cura freezed some seconds until the support appeared.
This didn´t happened in Cura 4.X.X. Wish I could propose more info about it
Thanks!
5axes commented
5axes commented
Whithout new information, no need to keep it open