/admeta

AdMeta Blockchain implementation - built on Substrate

Primary LanguageRustGNU General Public License v3.0GPL-3.0

AdMeta

This is the AdMeta blockchain implementation.

Getting Started

Rust Setup

First, complete the basic Rust setup instructions.

Run

Use Rust's native cargo command to build and launch the AdMeta node:

cargo run --release -- --dev

Build

The cargo run command will perform an initial build. Use the following command to build the node without launching it:

cargo build --release

Embedded Docs

Once the project has been built, the following command can be used to explore all parameters and subcommands:

./target/release/admeta -h

Run

The provided cargo run command will launch a temporary node and its state will be discarded after you terminate the process. After the project has been built, there are other ways to launch the node.

Single-Node Development Chain

This command will start the single-node development chain with non-persistent state:

./target/release/admeta --dev

Purge the development chain's state:

./target/release/admeta purge-chain --dev

Start the development chain with detailed logging:

RUST_BACKTRACE=1 ./target/release/admeta -ldebug --dev

Development chain means that the state of our chain will be in a tmp folder while the nodes are running. Also, alice account will be authority and sudo account as declared in the genesis state. At the same time the following accounts will be pre-funded:

  • Alice
  • Bob
  • Alice//stash
  • Bob//stash

In case of being interested in maintaining the chain' state between runs a base path must be added so the db can be stored in the provided folder instead of a temporal one. We could use this folder to store different chain databases, as a different folder will be created per different chain that is ran. The following commands shows how to use a newly created folder as our db base path.

// Create a folder to use as the db base path
$ mkdir my-chain-state

// Use of that folder to store the chain state
$ ./target/release/admeta --dev --base-path ./my-chain-state/

// Check the folder structure created inside the base path after running the chain
$ ls ./my-chain-state
chains
$ ls ./my-chain-state/chains/
dev
$ ls ./my-chain-state/chains/dev
db keystore network

Connect with Polkadot-JS Apps Front-end

Once the AdMeta node is running locally, you can connect it with Polkadot-JS Apps front-end to interact with your chain. Click here connecting the Apps to your local AdMeta node.

Run in Docker

First, install Docker and Docker Compose.

Then run the following command to start a single node development chain.

./scripts/docker_run.sh

This command will firstly compile your code, followed by the whole unit test run, and then start a local development network.

Test

Unit Test

Run cargo test command to build and launch all unit tests. The unit tests will stop if all tests pass or any of them fails.

cargo test

Test with WebApp

Please see the AdMeta WebApp guide about how to test using AdMeta WebApp to interact with AdMeta Testnet.

License

GPLv3