Flow sensor controller firmware for Particle Photon and Electron hardware. Provides meter readings over serial port and Wifi (Photon) or cellular (Electron) network connections.
To build and flash your particle device, load the main.ino file into the Particle IDE and flash it to your device. That's it!
The following pins are configured:
D1- Flow metermeter0D2- Flow metermeter1D3- Flow metermeter2D4- Flow metermeter3
Most flow meters require a pull-up resistor for proper operation. Consult your meter's documentation.
There are three ways to read meter data from the device:
- Serial interface: Connect directly to the serial port. This interface is always running.
- TCP interface: Connect to the device on a TCP port.
- Cloud interface: Publishes a message to the Particle cloud using Particle.publish(). This interface is active when no TCP clients are connected.
The firmware runs a TCP server on port 8321 where meter readings are
published. A single client at a time can connect to this port.
Example:
$ telnet 192.168.1.7 8321
info: kegboard-particle device_id=1234abcd1234abcd00001111 version=0.1.0
kb-status: meter0.ticks=0 meter1.ticks=0 meter2.ticks=0 meter3.ticks=0
kb-status: meter0.ticks=16 meter1.ticks=0 meter2.ticks=0 meter3.ticks=0
Meter updates are also published on the serial port, in the same message format as the TCP server.
If there is no TCP client connected, the device will instead report status, up to once a second, to the Particle Cloud.
Log in to the Particle logs console to see events.
Offered free and open source under the MIT license. See LICENSE.txt.