- Compatible with 9mm and 6mm belts
- Compatible with bearings OR idlers
- Mix and matchable configurations
Each spacer is asymmetric. One side (shorter) is for use with air (do not use it). The longer side is for use with gates idlers or bearing stacks. RatRig idlers (12mm height) can be used if you add two M5x1mm shims away from belt center separation. 6mm idlers (10mm height) will require multiple shims away from belt center separation (think of the center as the space between belts).
The not-mid-post spacer is 2mm thick and 8mm diameter. Belt edges on Voron machines are 4mm apart. Most flanges are ~1mm thick.
Minor grinding (.1mm or so) of screw lengths may be required for a couple fasteners depending on individual carriage tapped thread depth. Fasteners are specified for absolute maximum thread engagement.
| QTY | Item | Notes |
|---|---|---|
| 2 | Gates GT2 9mm Smooth Idler | If using smooth idlers and 9mm belts |
| 2 | Gates GT2 9mm Toothed Idler | If using 9mm belts |
| 4 | F695 Bearing | If using bearings as smooth idlers for 6 or 9mm belts |
| 2 | 695 Bearing | If using bearings as smooth idlers and 9mm belts |
| 8 | MR95 Bearings | If wanting to replace the Gates idler bearings |
| 6 | M5x16mm FHCS | If your extrusion or x beam has shallow holes/slots, you may need to remove .2mm. Built around 6mm slot depth with DIN-7991 specifying 3.1mm head height. |
| 8 | M3x16mm FHCS | For pulley spacers (4x per side) |
| 8 | M3x10mm FHCS | For non-pulley spacers (4x per side) |
| 8 | M3x8mm FHCS | For attachment to Y axis carriages |