This tool lets you get a serial console on an Apple Silicon device and reboot it remotely, using only another Apple Silicon device running macOS and a standard Type C cable.
I have no idea what I'm doing with IOKit and CoreFoundation -marcan
This is based on portions of ThunderboltPatcher and licensed under Apache-2.0.
- Copyright (C) 2019 osy86. All rights reserved.
- Copyright (C) 2021 The Asahi Linux Contributors
Thanks to t8012.dev and mrarm for assistance with the VDM and Ace2 host interface commands.
To have access to the serial console device on macOS Monterey (12), you need to disable the AppleSerialShim extension.
Note: This requires downgrading the system security and may cause problems with upgrades. Use it at your own risk!
Start by generating a new kernel cache, without the AppleSerialShim extension:
sudo kmutil create -n boot -a arm64e -B /Library/KernelCollections/kc.noshim.macho -V release -k /System/Library/Kernels/kernel.release.<soc> -r /System/Library/Extensions -r /System/Library/DriverExtensions -x $(kmutil inspect -V release --no-header | awk '!/AppleSerialShim/ { print " -b "$1; }')
Replace <soc> with t8101 on M1 Macs and t6000 on M1 Pro/Max Macs. If you’re unsure, uname -v and look at the end of the version string (RELEASE_ARM64_<soc>).
Then, enter 1TR:
- Power off your Mac
- Press and hold the Power button until the boot menu appears
- Select “Options”, then (if necessary) select your macOS volume and enter your administrative password.
Select Utilities>Startup security and switch the macOS installation to reduced security. Exit Startup security.
Select Utilities>Terminal and install your custom kernel:
kmutil configure-boot -c /Volume/<volume>/Library/KernelCollections/kc.noshim.macho -C -v /Volume/<volume>
Replace <volume> with the name of your boot volume.
You can now reboot: macOS should start as normal, and the serial device /dev/cu.debug-console should be available.
To revert back to the default kernel, enter 1TR again, access Utilities>Startup security and switch to full or reduced security.
Install the XCode commandline tools and type make.
Connect the two devices via their DFU ports. That's:
- the rear port on MacBook Air and 13" MacBook Pro
- the port next to the MagSafe connector on the 14" and 16" MacBook Pro
- the port nearest to the power plug on Mac Mini
You need to use a USB 3.0 compatible (SuperSpeed) Type C cable. USB 2.0-only cables, including most cables meant for charging, will not work, as they do not have the required pins. Thunderbolt cables work too.
Run it as root (sudo ./macvdmtool).
Usage: ./macvdmtool <command>
Commands:
serial - enter serial mode on both ends
reboot - reboot the target
reboot serial - reboot the target and enter serial mode
dfu - put the target into DFU mode
nop - do nothing
Use /dev/cu.debug_console on the local machine as your serial device. To use it with m1n1, export M1N1DEVICE=/dev/cu.debug-console.
For typical development, the command you want to use is macvdmtool reboot serial. This will reboot the target, and immediately put it back into serial mode, with the right timing to make it work.