- Connect RPI Pico with micro usb cable (that supports data transfer) to your PC
- Install RPI Pico firmware
- Use Thonny IDE to upload all files in this repo to the device
- Adjust the user + password in config.py
- Check IP address of the device (when
- Add the following settings in configuration.yaml
rest_command:
markise_hoch:
url: http://192.168.178.142:5000/up
method: POST
markise_runter:
url: http://192.168.178.142:5000/down
method: POST
markise_stop:
url: http://192.168.178.142:5000/stop
method: POST
markise_position:
url: "http://192.168.178.142:5000/set?target={{position}}"
method: POST
rest:
- resource: "http://192.168.178.142:5000/status"
scan_interval: 10
sensor:
- name: "MARKISE_POSITION"
value_template: "{{ value_json['state']['percent'] | round }}"