bondtech_fw_MK3s-16_3_8_0 Load/Unload issues.
Closed this issue · 1 comments
Cub3squar3d commented
Just installed the Bondtech upgrade on my Prusa Mk3s.
Everything looks fine, calibration completed without issues, test cube is nice.
The problem is that the load and unload sequences have the wrong length, and the filament doesn't quite reach the nozzle during load, and gets stuck after the gears during unloads, forcing a release of the thumbscrew to completely unload.
Cub3squar3d commented
My bad, manually updating the e-steps to 415 through console is required since it's not written to eeprom by the flashed firmware.