printer settings/general/gcode flavor=Marlin?

[Dweinbach]

I'm not sure I loaded the PrusaSlicer template correctly, but it does print. I'm curious if the printer settings/general/gcode flavor should be marlin or klipper. it seems to be set to Marlin in my case, but I didn't know if this was intentional.

[RizeCrime]

Yes, that is intentional.
Up until recently PrusaSlicer did not have a "Klipper" G-code flavor, so "Marlin" was the only option.
That said, since it does now have a "Klipper" flavor, it should work just the same, just try it out.