/DaVinci-Automatic-Filament-Tag-Reset

Uses an MFRC522 reader to automatically reset the tag to maximum spool length and allow 3rd party filament to be used with the DaVinci Jr 1.0 printer

Primary LanguageC++GNU General Public License v3.0GPL-3.0

DaVinci-Automatic-Filament-Tag-Reset

Note: This will be properly written up with pictures and more information in the future

I am not responisble for any damage to your hardware through the use of this code.

This uses an MFRC522 reader to automatically reset the tag to maximum spool length and allow 3rd party filament to be used with the DaVinci Jr 1.0 printer

This requires the following or similar hardware:

https://www.banggood.com/RC522-Chip-IC-Card-Induction-Module-RFID-Reader-p-81067.html?rmmds=myorder&cur_warehouse=CN

https://www.banggood.com/ATmega328P-Nano-V3-Controller-Board-Compatible-Arduino-p-940937.html?rmmds=myorder

This library is required for the sketch to function:

https://github.com/miguelbalboa/rfid

This uses code from https://nfckey.xyz/ to generate the unique key for the tag and so is licenced under the GPL to comply