/PiZeroW-Rubber-Ducky

A self driven project to make a modified version of a rubber ducky using a Raspberry Pi Zero W

Primary LanguageHTML

PiZeroW-Rubber-Ducky

A self driven project to make a modified version of a rubber ducky.

      _      _      _       _      _      _          _      _      _       _      _      _  
   __(.)< __(.)> __(.)=   >(.)__ <(.)__ =(.)__    __(.)< __(.)> __(.)=   >(.)__ <(.)__ =(.)__
   \___)  \___)  \___)     (___/  (___/  (___/    \___)  \___)  \___)     (___/  (___/  (___/

Steps

  1. GATHER PARTS AND ASSEMBLE
    • Attatch USB stem to Pi Zero by soldering
    • (OPTIONAL) Print case
  2. GETTING THE ENVIRONMENT SETUP

    • (SOFTWARE) Use balenaEtcher for Mac or Rufus for Windows

    • Download Raspbian Jessie Lite image and flash it to the SD card

    • Plug the SD in and open it's folder

    • Create a new file called ssh (The file will be left blank, it just needs to exist in the /boot folder(just the main folder with other junk in it))

    • Create a new file called wpa_supplicant.conf

      country=us
update_config=1
ctrl_interface=/var/run/wpa_supplicant

network={
scan_ssid=1
ssid="MyNetworkSSID"
psk="Pa55w0rd1234"
}

    • At this point you should plug the pi into your computer. The green light should be lighting up confirming that everything is connected and working properly.

    • From your terminal run

      ssh-keygen -R raspberrypi.local
ssh pi@raspberrypi.local

    • (SIDENOTE) The default password is raspberry

    • run the following commands (in the pi terminal)

      sudo apt update
sudo apt install git
git clone https://github.com/arrase/Raspiducky.git
cd Raspiducky
sudo chmod 777 install.sh
sudo ./install.sh
cd ..
sudo rm -rf Raspiducky
sudo reboot

    • A prompt should indicate that the pi is now being recognized as a keyboard. I was completing this on MAC and a prompt to setup a new keyboard appeard

  3. CREATING THE PAYLOAD
    • Remove the micro SD from the pi, plug into SD reader, and open it from your desktop
    • Create a new file in onboot_payload called payload.dd
    • This is the file where you can place the payload you would like to execute when the pi gets plugged in
  4. INSERT
    • Plug the pi into the USB port of target machine and watch the payload execute
    • Vwola!

Materials

  • 1x Pi Zero W
  • 1x Micro USB card (16GB)
  • 1x Pi Zero USB Stem
  • 1x USB Connector
  • 2x Nylon Bolt
  • 2x Nylon Screw

Resouces

List of already created scripts

Script Generator

Duckberry Pi

SetUp

SSH

Hotfixes

  1. Not turning on?
    • On the stem usb attatchment, make sure to solder the 4 usb contact points. I left these unsoldered and the pi zero would not turn on upon plugging in.
    • Also try installing another OS onto the SD. An incorrect image can cause the pi not to boot.