/VerilogA-Wave-Generator

The codes are used to generate the VerilogA code which can be directly used in the spectre simulation .The generated VerilogA code's fuction is to generate the specific waveforms according to your setting.And the setting is done in the python code (main.py), which will facilitate greatly the coding works.

Primary LanguagePython

The Verilog-A code generator

Usage

  1. modify the args in the main.py
  2. python main.py

Description

The codes are used to generate the VerilogA code which can be directly used in the spectre simulation .

The generated VerilogA code's fuction is to generate the specific waveforms according to your setting.

And the setting is done in the python code (main.py), which will facilitate greatly the coding works.

Special Notes

Due to the limit of the type integer holding values ranging from -2^31 to 2^31 - 1, the with of the input signal should not exceed 32 !!! If the signal's width > 32, you'd better split the signal into 2 signals.

Demo

The code below is the description about the waveform in python , including the I/O path, comment, module_name and waveforms info .

# input template file path
template_path ='./template.va'
# output file path
save_path = './generate.va'

# the comment in the veriloga file
comment = 'This file is generated by the VA_GEN .'
# the module name
module_name = 'Va_TimeGen_1'

# the expected output signals 
# signal-name | signal-width | waves-length | waves-value 
signal_args = [
    ['signal_1', 8, 4, [0, 1, 2, 3]],
    ['signal_2', 1, 4, [0, 1, 0, 1]]
]

The detailed meaning of the wavefoms info list is in the table below. The signal_args must contain at least 1 signal array.

signal[0] siganl[1] signal[2] signal[3]
meaning port name port width waves' length waves' values
example 'signal_1' 8 4 [0, 255, 128, 20]

When you have done the setting, you can execute python main.py to get the VerilogA code.

And then you can open the virtuoso and create a Verilog-A cell.

Note !!! The cell name must be consistent with the module_name in you setting.

img

Then you can use the editor to open the VerilogA file and copy the generated content to it.

Last, you can build the VerilogA.

If it goes well, the window will jump up. And you can enter yes to automatically genrate the symbol.

img

The symbol is just like this.

img

And you can invoke the VerilogA cell easily like this.

Note !!! The wave's frequency is consistent with the input clk frequency and the amplitude is consisitent with the input VDD-GND. So you must give the CLK, VDD and GND signals when invoking the module.

img

The simulation result is as below.

img