This is a set of device classes I use to control small components I use within my Arduino projects. They're very basic, and are all starter level development. I intend to enhance them as I learn more about Arduino and best practices.
A class that simply starts a buzzer for a time you specify by the beep function. The Loop function will then use the Buzzer's update method to handle when the buzzer should stop.
Buzzer(int Pin)
Constructor, Accepts a pin number to which the buzzer is connected.
Beep(int ToneTime)
The amount of time the tone should sound for. Usually called when you want the buzzer to start buzzing.
Update()
Update the state of the buzzer. Usually called from within the Loop function.
A class that allows you to flowly fade in and out, a LED.
FadingLed(int LedPin, int FadePeriod, int DelayedStart, bool Debug)
Constructor, Accepts a pin number to which the LED is connected, the time in milliseconds to go from bright to dim, a time in milliseconds to delay the start, and a flag to indicate if logging is needed.
Update()
Update the state of the LED. Usually called from within the Loop function.
A class allowing for a set and forget flashing LED.
FlashingLed(int LedPin, long On, long Off)
Constructor, Accepts a pin number to which the LED is connected, how long the LED should stay on for, and how long the LED should stay off for..
Update()
Update the state of the LED. Usually called from within the Loop function.
A very basic class that allows for turning a LED on and off.
LED(int Pin)
Constructor, Accepts a pin number to which the LED is connected.
On()
Turns the LED on.
Off()
Turns the LED off.
A class to manage a PIR (Motion Sensor) device.
PirSensor(int Pin)
Constructor, Accepts a pin number to which the PIR sensor is connected.
Check()
Check if the PIR sensor is detecting any movement.