ProfileServ Manual _________________________________________________________________ 1. Prerequisites and Installation. 1.1. Compiling and Installation 2. Basic Configuration Welcome to the ProfileServ Manual. This document will aid you in setting up and running ProfileServ on your IRC network. ProfileServ is a User Profile Service. 1. Prerequisites and Installation. ProfileServ is designed to run on Top of NeoStats 3. Please refer to the NeoStats website for more information on the requirements for NeoStats. ProfileServ requires the following: * NeoStats 3.0 or Higher correctly installed and Running * The time to read this entire document. 1.1. Compiling and Installation As long as you have successfully setup NeoStats, and installed it correctly, Compiling ProfileServ is very simple and straight forward. First you must extract the files from the download package. This is as simple as: bash$ tar -xzf ProfileServ-<ver>.tar.gz This should then create a directory called ProfileServ-<version> where <version> is the Version of ProfileServ. Then Proceed to Change into the ProfileServ directory, and run Configure as follows: bash$./configure [--with-neostats=<dir>] --with-neostats=<dir> should be used if your neostats directory is not in a standard location (~/NeoStats3.0/). Replace <dir> with the full path to your NeoStats installation directory (NOT SOURCE DIRECTORY) If the configuration did not produce a error, you may then move onto Compiling ProfileServ. Compiling is simply just issuing the "make" command (or "gmake" if you are running BSD): Again, check for Error messages. As long as there are not error messages, "make install" (or "gmake" if you are running BSD) will install ProfileServ, this README file, and any auxiluary files needed into your NeoStats directory: Once Installation is complete, you can either configure NeoStats to load ProfileServ when it starts, or load ProfileServ via IRC. To Configure NeoStats to automatically load ProfileServ when it boots, add the following line to your "neostats.conf" file in the NeoStats directory: LOAD_MODULE ProfileServ To load ProfileServ via IRC, you must make sure you have the appropriate permissions and issue the following command: /msg neostats load ProfileServ Thats it. ProfileServ is now loaded and ready for use (in fact, it will already be running now, but read on for futher information). 2. Basic Configuration By default, ProfileServ will use the Global Exclusions, will ignore any profile viewing or adding commands. To Disable the Global Exclusion list and only use the Local one (NOTE: Both can be used concurrently) use SET EXCLUSIONS OFF To enable the Profile Channel (Defaults to #Profile) use "SETENABLEPROFILECHAN ON", ProfileServ will then join the Profile Channel to accept Commands in channel. To Enable the Profile commands via Private message to ProfileServ, use "SET ENABLE ON"