/ha-ksenia-lares

Kaenia Lares (pre 4.0) integration for home assistant

Primary LanguagePythonMIT LicenseMIT

Home Assistant Ksenia Lares integration

hacs_badge

Ksenia Lares 48IP integration for home assistant. Compatible with BTicino alarm systems.

This integration will set up the following platforms.

Platform Description
binary_sensor For each zone, defaults to movement sensor.
sensor For each partition, showing the ARM status.
alarm_control_panel ARM and disarm based on partitions and scenarios
switch Bypass zones/partitions

Requirements

This integration relies on the web interface to be activated, this is not always the case. Please contact your alarm intaller for more information on activation.

Installation

Installation via HACS

Open your Home Assistant instance and open a repository inside the Home Assistant Community Store.

  1. Open HACS
  2. Goto the menu in to top right corner
  3. Goto custom respositories
  4. Add this repositry https://github.com/johnnybegood/ha-ksenia-lares
  5. Click explore & download respositories
  6. Search for and add "Ksenia Lares"
  7. Restart Home Assistant
  8. In the HA UI go to "Configuration" -> "Integrations" click "+" and search for "Ksenia Lares" or click the button below.

Open your Home Assistant instance and start setting up a new integration.

Installation directly

  1. Using the tool of choice open the directory (folder) for your HA configuration (where you find configuration.yaml).
  2. If you do not have a custom_components directory (folder) there, you need to create it.
  3. In the custom_components directory (folder) create a new folder called ksenia_lares.
  4. Download all the files from the custom_components/ksenia_lares/ directory (folder) in this repository.
  5. Place the files you downloaded in the new directory (folder) you created.
  6. Restart Home Assistant
  7. In the HA UI go to "Configuration" -> "Integrations" click "+" and search for "Ksenia Lares" or click the button below.

Open your Home Assistant instance and start setting up a new integration.

Configuration

Mapping Alarm

The KSENIA Lares alarm uses more complex scenarios then the default states of the home assistant alarm (away, night, home). A mapping is needed between the Home Assistant states and the KSENIA Lares scenarios (for activation) and zones/partitions (for state).

Go to integration to setup the mapping.

Bypass zones

To be able to bypass zones, you will need to configure a PIN to be used.

  1. Go to integration
  2. Click 'Configure'
  3. Enter the PIN code to use (it will need to be entered again each time the configuration screen is used).