K2-Camera

A work around to get the camera working in fluidd.

This requires root access to be enabled on the printer.

Firmware updates may remove the changes so you may have to run the commands again after a firmware update.
With any luck creality just implements this so we dont have to perform this modification.

https://www.youtube.com/watch?v=XHLAtVG9Bcg

Install Commands

python -c "from six.moves import urllib; urllib.request.urlretrieve('https://github.com/DnG-Crafts/K2-Camera/archive/refs/heads/main.zip', '/root/main.zip')" 
python -c "import shutil; shutil.unpack_archive('/root/main.zip', '/root/')"
sh ~/K2-Camera-main/install.sh

if you wish to restore the printer to its original configuration then run the commands below

Restore Commands

sh ~/K2-Camera-main/restore.sh