Firmware for the alternative realtime music visualizer board inspired by Lumazoid from nootropic design. Changes from the original Lumazoid project are:
- input from microphone module MAX9814 (to A1)
- IR remote control is added
- number of LEDs is variable and may be any (200 is max, due to Nano V3.0 memory limit)
- all buttons and potentiometers are removed (IR RC is the only control)
- new visualization modes were added
- bands were mixed to get all Low, Middle and High bands even on small set of frequencies bands
- Lamp mode (with ajustable brightness)
- Button to assign favorit mode to Remote Control's digital key (NEW in v2)
- LEDs to signal modes: On, Off, Button assign (NEW in v2)
Color modes:
- Randomized color
- Cycle color change
- Band's base color + fractional part
- Pure Band's base color
Visualization modes:
- Dance party (dots move from center to sides)
- Dance party mirrored (dots move from sides to center)
- Dance party single side (dots move from left to right)
- Dance party single side mirrored (dots move from right to left)
- Pulse (pulsation from center)
- Light bar (whole strip blinking, stroboscope)
- Color bars (multiple bars of fixed width)
- Color bars 2 (multiple bars of variable width)
- Color bars 3 (several bars of variable width, wider than previous)
- Flashbulbs (flashing dots)
- Fireflies (moving dots)
- Mirage (bars in fixed positions, one for each band)
- Mirage mirrored (bars in fixed positions, mirrored, two for each band)
Install libraries/ffft in your Arduino sketchbook libraries folder.
Requires:
Your directory structure should look like this:
your_sketchbook
|
+--libraries
| |
| +--ffft
| |
| +--Adafruit_NeoPixel
| |
| +--IRLremote
|
+--Lumazoid
|
+--Lumazoid.h
+--Lumazoid.ino
In the Arduino IDE, select board type "Arduino Nano" to upload to the Lumazoid.
