Motion Webcam Server Plugin

Description

This plugin runs the motion webcam streaming service as a DSF plugin. The main motion.conf file is accessible via 0:/sys/motion.conf.

Note that the default configuration uses the default /dev/video0 device node, which is generally applicable to external USB webcams. Depending on your choice of camera, extra customizations may be required.

Setup in DWC

To configure this service in DWC, go to the Settings -> General page and make the following changes:

Set Webcam URL to http://[HOSTNAME]:8081/0/stream
Set Webcam update interval (in ms) to 0
Go to the Job -> Webcam page to see your live stream

Build instructions

Create a ZIP file of every file in the src directory and make sure plugin.json is at the root level. Once created, the ZIP can be installed as a third-party plugin. If a Debian package is supposed to be generated, check out to the pkg/build.sh script.

Logging

Unfortunately this service outputs info and warning log messages even if the log level is initially set, so by default this plugin's configuration suppresses all the log messages and only sends them to the duetpluginservice journal log.

Checking the journald log (recommended way)

To view the log of the motion service, open a Linux console (or connect over SSH) and run

journalctl -u duetpluginservice -f

Then restart the Motion Webcam Server plugin and look for potential errors.

Modify plugin manifest to see all messages in DWC

To see all the output messages from the motion service directly in DWC, open plugin.json and set sbcOutputRedirected from false to true. Then build the plugin again and overwrite the existing installation. Once the plugin is restarted, all the log messages are written to the DWC console.

Increasing the log level

If you need further details, you can reset log_level in motion.conf from 3 (critical) to 6 (notice). Note that a restart of the plugin is required whenever the config file is modified.

Duet3D/MotionWebcamServerPlugin