Just my set of configs for the Artillery Genius Pro running Klipper.
- Artillery Genius Pro Stock - works very well
- Artillery Genius Pro SKR3 + LGX + EBB42 - works flawlessly
LGX Over extrusion, basic calibrationLinear Rails on all axisEBB42 1.2 on USB insteadcombined with the Genius EBBEBB42 ADXL and Bltoutch- CANbus for the EBB, removing Artillery's shitty EBB and flimsy flat cable
- Raspberry Pi mount inside the printer
- LED mount on top
- LGX ACE Mosquito, CHT Nozzle, 24v Heating cartridge
- Bigtreetech SKR3 EZ with EZ-TMC2209 drivers
- Bigtreetech EBB42 1.0 running Klipper
- PT1000\ATC Semitec 104NT-4-R025H42G thermistors
- Linear Rails
- ADXL345 input shaper (using EBB42)
- Jetson Nano as the Moonraker\Octoprint\Mainsail server
- Antclabs Bltouch 3.1
I've flashed Klipper using USB even though this specific chip does not support it and should be flashed using SD Card - it didn't work for me.
At the moment, bootloader is skipped and I can't revert to Marlin - be careful if you ever want to.
Set your config to the following:
and use dfu-util -a 0 -s 0x8000000:leave -D out/klipper.bin
Here are the relevant projects I've used - all respect goes to them! Z Linear Rails:
X Linear Rails:
Rod support:
Brace support:
- https://www.thingiverse.com/thing:4601974
- https://www.thingiverse.com/thing:4770873
- https://www.thingiverse.com/thing:4718116
Belt tensioners:
Several considerations:
- Original Artillery mechanical endstops do not work with the SKR3; I had to revert to the generic 2-wired endstops
- Bltouch and Input Shaper settings needs to be defined in the printer.cfg for it to be modified by Mainsail
- LGX current needs to be around .650 RMS to avoid skippings