** DISCLAIMER ** I AM NOT RESPONSIBLE FOR DAMAGE TO YOUR HEARING, HARDWARE OR ANYTHING ELSE IF YOU USE THIS APPLICATION/PROGRAM! ITS A CONCEPT, SO EXCPECT THE UNEXPECTED!
SoundOverSerial, play sound from your computer to your stm32f0 over usart/serial. It sends over everything you would normally hear over your speakers, without installing drivers. With practically no delay :D.
- Magic
- Make sure your audio device is set to 48000hz/16-bit as shown here:
- Make sure both dll and executable are together
- Connect your stm32f0 discovery using a serial to usb converter
- Connect your speaker/speaker out/3.5mm out jack -For PWM: Use pin PC7 -For DAC: Use pin PA4
- Launch the executable and follow the instructions there!
Warning (seriously scary loud noise can occur)!:
- Make sure your volume is not to high when either (best to disconnect/reconnect after these changes are applied):
- Switching on the stm32f0
- Connecting via the executable
- Switching from PWM to DAC and vice versa application side
- Switching from PWM to DAC and vice versa on the microcontroller
- NAudio - Awesome audio library for C#/.NET