EmotiBit/EmotiBit_Cases

Issues

• SwissArmyCase: Close space over button

  #10 opened 2 years ago by produceconsumerobot
  0

• SwissArmyCase: Chamfer slider top outer corners to prevent catching on case

  #17 opened 2 years ago by produceconsumerobot
  0

• SwissArmyCase: Consider shrinking slider hole width to better match slider width

  #16 opened 2 years ago by produceconsumerobot
  0

• SwissArmyCase: Add 4 small pillars/lips to hold Feather from unplugging out of Emotibit in case

  #11 opened 2 years ago by produceconsumerobot
  0

• SwissArmyCase: Make USB hole smaller

  #15 opened 2 years ago by produceconsumerobot
  0

• SwissArmyCase: Add clips onto case body to hold onto EmotiBit PCB

  #14 opened 2 years ago by produceconsumerobot
  0

• SwissArmyCase: Add case support feat to prevent bending emotibit PCB

  #13 opened 2 years ago by produceconsumerobot
  0

• SwissArmyCase: Consider if there's a way to make the reset button finger pushable

  #12 opened 2 years ago by produceconsumerobot
  0

• Make the SwissArmyCase slider and screws thinner for the HUZZAH32

  #9 opened 2 years ago by produceconsumerobot
  0

• Add a chamfer to the swiss army case slider

  #7 opened 2 years ago by nitin710
  0

• Change V1 to "Alpha" and add disclaimer to how it fits on Beta boards

  #1 opened 3 years ago by produceconsumerobot
  0