With this you are able to clone your RFID tag
📝Necessary modules and stuff
- Arduino Nano
- Oled Display 0.96 Inch
- RC522 RFID Module
- 2 Buttons
- 2x Resistor with 220 Ohm (for buttons !)
- Bread Board
- Some Wires (about 20pcs)
- Arduino SD Card Module (Used only for DonkRFID-OledV3-SaveToSD-Card.ino)
Optional for more precisely use.
- 2x LED Diodes (RED and GREEN) and 2x 220 Ohm resistor (if u use LEDs)
- Just added for show status (RED lights up if emulating or reading failed and green for opposite)
- SDA -> D10
- SCK -> D13
- MOSI -> D11
- MISO -> D12
- IRQ -> Not connected
- GND -> GND
- RST -> D9
- 3.3V -> 3.3V
- VCC -> 5V
- GND -> GND
- SDA -> A4
- SCL -> A5
- VCC -> 5V
- GND -> GND
- MISO -> D12
- MOSI -> D11
- SCK -> D13
- CS -> D4
- Button Read -> D2
- Button Emulate -> D3
- GREEN LED -> D5 (throught 220 OHM resistor)
- RED LED -> D6 (throught 220 OHM resistor)