/slave_motor

Primary LanguageC++

slave_motor

Equipment used:

  • Arduino Uno R3 Board + CNC Shield V3
  • Step motor driver - A8825

Building the system:

  • Slave - Arduino Uno R3 + CNC Shield V3:
  • After receiving the signal to classify garbage, the circuit will process and control the motor to rotate in the correct direction to put the garbage into the bin.
  • After the process is completed, it will respond to the ESP8266 to notify that a new process can be started.

Libraries used:

  • AccelStepper
  • Wire

IDE Platform:

  • PlatformIO
  • Arduino IDE

Installation guide:

  • For the Arduino Uno R3 + CNC Shield V3 circuit, download the code, download the appropriate libraries, and then upload the code, adjust the current to match the motor on the A8825 driver.

NOTE:

  • When uploading code, remove the SDA and SCL pins, and after the code is uploaded, they can be plugged back in.
  • Connect the motor to the circuit before powering on the CNC Shield V3.