/TinyBoy-2

TinyBoy 2 Data Source

OtherNOASSERTION

TinyBoy(TM) 2

A 3D Printer for Kids.

This repo are stored all the Blue Prints and design diagrams. The TinyBoy design comes ABSOLUTELY NO WARRANTY!

TinyBoy(TM) 2 by Hong Kong Creative Open Technology Association (HKCOTA), blueprints and designs are licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0).

To view a copy of this license, visit https://creativecommons.org/licenses/by-nc-sa/4.0/legalcode.

You are free to:

  • Share — copy and redistribute the material in any medium or format
  • Adapt — remix, transform, and build upon the material

Under the following terms:

  • Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.

  • NonCommercial — You may not use the material for commercial purposes.

  • ShareAlike — If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.

TinyBoy Projects are also using the hardware and firmware from the following projects:

Melzi Projects, For L10/L16

  • using MKS's Melzi clone board, SMELZI, which should be licensed under GPL 2.0. MKS said it is possible to get the board design if you ask them. But we have doubt on it. The printers, which are produced by MakeOmnia Ltd., would still use this board. The version L10/L16 are supported by MakeOmnia Ltd. only.

RMAPS v1.4, For Lite/J10

  • which is licensed under GPL. As HKCOTA have doubt on the board, so for the HKCOTA version, we choose to use RAMPS v1.4 + Arduino as the main board of the printer. And it would be supported by HKCOTA and its community.

Marlin Firmware project