Pinned Repositories
ASS_mobile
login page
Data-minning-project
Code to classify articles
embedded_C_code
Write embedded C code using the ATmega32 to make a calculator using both the keypad and the LCD display. Requirements: The calculator is allowed to do only one operation at a time. Note: Use ON/C to clear the LCD display .
embedded_C_code2
Implement two drivers, the first for the LED and the second for the push button. Notes: These drivers should be configurable to be able to use any LED or any push button. Also, we should be able to use many LEDs together in the same project using the same LED driver. The same applies to the push button.
embedded_C_code3
Write Embedded C code using ATmega32 control 4-LEDs by external interrupt INT1.The first LED is lit and roll down to the last LED then back to the first LED. This operation is done continuous. Enable the internal pull up resistance at INT1 pin (PD3). When the INT1 is triggered all the LEDs flash five times in five seconds.
graduation-project
Haneen2002
Config files for my GitHub profile.
https-github.com-Haneen2002
My Personal Profile
NDB
insert into and delete from NDB
X-O
xo project in assembly language
Haneen2002's Repositories
Haneen2002/ASS_mobile
login page
Haneen2002/Data-minning-project
Code to classify articles
Haneen2002/embedded_C_code
Write embedded C code using the ATmega32 to make a calculator using both the keypad and the LCD display. Requirements: The calculator is allowed to do only one operation at a time. Note: Use ON/C to clear the LCD display .
Haneen2002/embedded_C_code2
Implement two drivers, the first for the LED and the second for the push button. Notes: These drivers should be configurable to be able to use any LED or any push button. Also, we should be able to use many LEDs together in the same project using the same LED driver. The same applies to the push button.
Haneen2002/embedded_C_code3
Write Embedded C code using ATmega32 control 4-LEDs by external interrupt INT1.The first LED is lit and roll down to the last LED then back to the first LED. This operation is done continuous. Enable the internal pull up resistance at INT1 pin (PD3). When the INT1 is triggered all the LEDs flash five times in five seconds.
Haneen2002/graduation-project
Haneen2002/Haneen2002
Config files for my GitHub profile.
Haneen2002/https-github.com-Haneen2002
My Personal Profile
Haneen2002/NDB
insert into and delete from NDB
Haneen2002/X-O
xo project in assembly language