Koruza-hs-rigid PCB board is an add-on for the main koruza-CM board. It is used to connect the communication/configuration signals of both SFP modules to the koruza-CM board. Also, the external SFP port with the cage is mounted to that board.
On top of this board koruza-hs-flex PCB is placed, and it connects to it using header pins. The ground signal is connected thru the cage pins.
This board is in development and testing phase, for all information see the schematic PDF file. Produced board versions can be found in the release section of the repository.
Latest release: v0.2
All comments and suggestions can be added to the Issues section of the repo. For additional details see the Issue section.
Soldered prototype:
3D model in EDA software tool:
We strive to make KORUZA as usefully open-source as possible. Hardware including documentation is licensed under CERN OHL v.1.2. license
Firmware and software originating from the project is licensed under GNU GENERAL PUBLIC LICENSE v3.
Open data generated by our projects is licensed under CC0.
All our websites and additional documentation are licensed under [Creative Commons Attribution-ShareAlike 4 .0 Unported License] (https://creativecommons.org/licenses/by-sa/4.0/legalcode).
What this means is that you can use hardware, firmware, software and documentation without paying a royalty and knowing that you'll be able to use your version forever. You are also free to make changes but if you share these changes then you have to do so on the same conditions that you enjoy.
Koruza, GoodEnoughCNC and IRNAS are all names and marks of Institut IRNAS Race. You may use these names and terms only to attribute the appropriate entity as required by the Open Licences referred to above. You may not use them in any other way and in particular you may not use them to imply endorsement or authorization of any hardware that you design, make or sell.