ICB Toolchain Demo

Modified: 2022-09

Demo of using CMake to create a toolchain for building and flashing firmware for the Incuvers Control Board. I have supplied a sample program which blinks the SCK LED (PORTB1) at 2Hz. It also uses an ISR tied to the interrupt vector for completed usart reception to echo characters back to a serial console.

Setup

You will need avr-libc and the avr code generation tooling. On MacOSX you can use homebrew to install these dependancies:

brew tap osx-cross/avr
brew install avr-gcc

Your code generation tools root should be under /usr/local/bin try running avr-gcc --version in the terminal to ensure it is found.

Configuration

You will need to define the serial device for the control board. Furthermore the following programs need to be found in the CGT_ROOT path:

avr-gcc
avr-objcopy
avrdude
avr-g++
avr-strip

Once this is confirmed update the cmake definitions in the CMakeLists.txt:

set(SERIAL_PORT "/dev/tty.usbserial-A10JTC54")
set(CGT_ROOT "/usr/local/bin")

Run the cmake project configuration:

mkdir build
cd build
cmake ..

Compilation

Compile the firmware to .elf format and then object copy to .hex:

make -j4

Flashing

Flash the .hex binary to the control board:

make flash

The SCK should blink at 2Hz:

Fuse Configuration

I've added a fuse directive to setup the chips fuses according to the ATMEL2560:

make fuses

Demo

Open a serial console to the control board by targetting the usb device in /dev and run at 115200 baud:

$ screen /dev/yourusbdevice 115200
...
type some random stuff in the console and ensure characters echo back.

To exit screen: ctrl+a to enter command mode, then press k for kill and then press y to confirm kill

Incuvers/icb-toolchain