Unofficial scripts for installing Pterodactyl on both Panel & Daemon.
Read more about Pterodactyl here. This script is not associated with the official Pterodactyl Project.
This project is available at GitHub with read-only forks available at GitLab and Bitbucket.
List of supported installation setups for panel and daemon (installations supported by this installation script).
Operating System | Version | nginx support | Apache support | PHP Version |
---|---|---|---|---|
Ubuntu | 14.04 | 🔴 | 🔴 | |
16.04 | ✅ | 🔴 | 7.2 | |
18.04 | ✅ | 🔴 | 7.2 | |
Debian | 8 | ✅ | 🔴 | 7.3 |
9 | ✅ | 🔴 | 7.3 | |
10 | ✅ | 🔴 | 7.3 | |
CentOS | 6 | 🔴 | 🔴 | |
7 | ✅ | 🔴 | 7.3 | |
8 | ✅ | 🔴 | 7.2 |
Operating System | Version | Supported |
---|---|---|
Ubuntu | 14.04 | 🔴 |
16.04 | ✅ | |
18.04 | ✅ | |
Debian | 8 | 🔴 |
9 | ✅ | |
10 | ✅ * | |
CentOS | 6 | 🔴 |
7 | ✅ | |
8 | ✅ |
* Debian 10 is not listed as officially supported by Pterodactyl yet.
Using the Pterodactyl Panel installation script:
bash <(curl -s https://raw.githubusercontent.com/VilhelmPrytz/pterodactyl-installer/master/install-panel.sh)
Using the Pterodactyl Daemon installation script:
bash <(curl -s https://raw.githubusercontent.com/VilhelmPrytz/pterodactyl-installer/master/install-daemon.sh)
The script will guide you through the install.
Note: On some systems, it's required to be already logged in as root before executing the one-line command.
The installation scripts do not configure your firewall automatically.
On Debian and Ubuntu, ufw
can be used. Install it using apt
.
apt install -y ufw
Allow HTTP/HTTPS connections for panel installation.
ufw allow http
ufw allow https
Allow 8080 and 2022.
ufw allow 8080
ufw allow 2022
Make sure to also enable SSH (or allow SSH from your IP only, depending on your setup).
ufw allow ssh
Enable the firewall.
ufw enable
On CentOS, firewall-cmd
can be used.
Allow HTTP and HTTPS.
firewall-cmd --add-service=http --permanent
firewall-cmd --add-service=https --permanent
Allow 8080 and 2022.
firewall-cmd --add-port 8080/tcp --permanent
firewall-cmd --add-port 2022/tcp --permanent
firewall-cmd --permanent --zone=trusted --change-interface=docker0
Reload the firewall to enable the changes.
firewall-cmd --reload
Feel free to fork the project and send a PR! 😃