JaredC01/Galileo2

Part broke during filament loading/tightening

sharpner opened this issue · 4 comments

sharpner commented

I had this part break for me either during filament loading or maybe I tighten the screw/wrong too much?
image

It then clogged the filament path until I cleaned it up.
image

But I just screwed the g2e together and I am printing fine - so I wonder if that could be improved without actually holding the bearing with a small wall.

sharpner commented

IMG_4207

And it happened again... am I the only one? Am I doing something wrong?

I have no clue what's going on here - will test to print that part now in ASA

sharpner commented

I wonder how this should be sliced, with extrusion width of 0.45 its only two walls
image
but with extrusion width of 0.4 its three
image

JaredC01 commented

This has happened on a few occasions, though I'm not 100% sure of the cause yet. You can adjust the extrusion width and test, and please let me know the results. I can't make a "fix" to the issue until I understand the cause, so any help with that would be appreciated.

sharpner commented

I understand, I am just happy that I am not the only one.

Will let you know if it breaks again, last time it took 4-5 months :D

I printed the part in ASA with 0.5 extrusion width so it resulted in exactly 1mm wall