Any plans to give us access to the filament path without disassembling the toolhead?
laserbeak opened this issue · 1 comments
laserbeak commented
OK so i expected to run into this flaw with G2E but not so soon. The filament path is obstructed. If this were my CW2, I could just open the latch and pull anything out with my needlenose pliars...
I have to wait for my printer to cooldown and take the whole toolhead apart...
laserbeak commented
Well, My PTFE was too short. I didn't push it down far enough into the hotend before measuring for the extruder.
That problem is gone.
Hopefully a planetary gear setup won't have clogs sitting at the top of the tube. I guess the true test will be my first TPU print...