2021-09-03
Honeywell Controller Project
Overview
// 'HWCONFIG'
Is a filesys that contains the actual ".XML"
Containing the actual:
-
"modulating controller"
&&
-
"installer settings"
(Procedure for Dual Systems)
-
Load installer settings from the USB connection.
-
On your primary (ie largest connected to controller) air unit.
-
MY primary happens to be on my 1st floor. Ie MY "downstairs" controller.
-
Then load this versioning. To your secondary (MY "upstairs") controller.
-
To ensure a syncronized at the primary
-
Airs Circulation
&&
-
Fire Suppression Controls
-
-
Which is then what's used for the below
'HowTo'
// Honeywell Firmware
Website: https://thermostatsetup.com/thermostat_setup/en/prestige/software
-
downloadLink (1)(v-Advanced-Controller)
'https://thermostatsetup.com/thermostat_setup/en/prestige'
-
downloadLink (2)(v-Basic-Controller)
'https://thermostatsetup.com/thermostat_setup/en/vision_pro'
(1)
This ^ one is used to error the controller's maintenance mode.
Allowing a manual selection for the manufacturer.
To flash software && over-ride in appropriate
"good faith"
.(2)
It is included in the filesystem.
That you fork from this repo.
To proceed.
/* Instructions on HowTo Flash Honeywell Controller */
// 0
Remove battery from back on the "Honeywell Controller"
// 1
Plug flash drive into the bottom of the controller
// 2
Hit
-> 'Load installer settings'
// 3
Enter the installer password Note (1)
- Is the "Date Code"
- Listed in the details
- For installed controller (in the UI) Note (2)
- Date code is '1850'
// 4
Load the contents of
-> / HWCONFIG /
Specifically the "XML" file of
-> 'ISUCON00.XML'
Displayname:
20210703installerSetupDownloadToUsb
- ^ Should be shown on UI
Model:
THX9001R5029
- For ^ model of the Honeywell Controller
// 5
Select the displayed
-> Configuration
--> '20210703installerSetupDownloadToUsb'
There is a single selection. Corresponds to the 'ISUCON00.XML'
.
// 6
Load '20210703installerSetupDownloadToUsb'
as the firmware.
For this installation as an "installer". To your controller.
Ie
-
You are overwriting the previous "configured" firmware
-
With MY
'20210703installerSetupDownloadToUsb'
versioning -
MY default is
// Configured for my
epilepsy
+neuropathy
🔃 onLoad 🔃
// Is -> Unlocked -> 75 min && 82 max -> Recurring scheduled (Twice daily)(0200 && 0700)
// 7
In Review
-
You should have...
[✅] Reset your Honeywell Controller
[✅] With
'20210703installerSetupDownloadToUsb'
-
You should be...
[✅] Looking at an unlocked screen
[✅] Looking at an unlocked screen with full interactibility
Of
â–¶ "UI Elements"
â–¶ "Mutability" (Displayed Values)
-
If this resolves to...
[✅]
'TRUE'
[🥳] Congratulations! You've succeeded!
LICENSE
Honeywell Controller Project - README.md
2021-09-03
v.1.0.0
MIT License
Copyright (c) 2021 Jeffrey Bodin