JimBrown/MarlinTarantula
Optimized firmware for RepRap 3D printers based on the Arduino platform. Configured for Tevo Tarantula
C++GPL-3.0
Issues
- 0
Correct nozzel offsets
#83 opened by clawszilla - 1
Update Nozzel Offsets
#80 opened by clawszilla - 1
Update Sensor Offsets
#81 opened by clawszilla - 1
Get Hermera PID Settings
#82 opened by clawszilla - 1
Error after Nozzle heating
#77 opened by Nalofox - 1
- 1
Few questions about this project
#74 opened by gytis-ivaskevicius - 2
Micro vibrationos printing on curves.
#72 opened by paulorfo - 1
Marlin 2.0 easy config m999 reset heater error
#71 opened by KirkSturg - 1
upload issue
#70 opened by dimaknight1109 - 1
Please add SERVO_PROBE_OPTIC_ENDSTOP
#69 opened by peekpt - 2
Bed hitting frame when probe is probing the bed.
#67 opened by Haxk20 - 4
SD Card, Cannot read
#65 opened by 3D-og - 3
- 2
Print From Sd Not Working
#64 opened by djice024 - 3
MINTEMP getting thrown on E1 hotend
#63 opened by nrgbistro - 2
Z_PROBE_OFFSET_FROM_EXTRUDER not honored
#60 opened by cdaringe - 1
Prints Mid Air
#58 opened by pirogeth - 1
- 1
- 1
feature request: faster UBL preheat
#59 opened by cdaringe - 2
Code assumes print bed is 200mm wide, my OOB tevo tarantula bed is 220mm wide (x-axis)
#55 opened by nikolac - 2
extruder selection
#39 opened by busrevi - 0
Z-min Always triggered. Even with no sensor plugged in. Even with logic inverted.
#57 opened by NedgoIO - 0
Compilation error when BLTouch sensor is enabled
#56 opened by jemifdo - 1
Why not in main marlin repro?
#54 opened by boelle - 3
Configured for Tevo Tarantula
#52 opened by pedro151 - 1
- 4
Bltouch wont deploy when homing
#49 opened by pirogeth - 1
- 1
Z lift disables Z stepper driver
#48 opened by vansoest - 1
- 0
- 4
Compile error in temperature.cpp
#45 opened by gjelsoe - 2
- 4
tevo firmware
#43 opened by MaTchoMAN - 9
#define UBL
#42 opened by biela-info - 3
- 1
- 4
M303 and E3D V6 Heating Failed on v2.0.x
#38 opened by XxInvictus - 2
Full graphic sidplay
#37 opened by f-wilhelm - 2
- 1
Sentence formation is incorrect.
#36 opened by satyagupta - 1
EEPROM data Size
#33 opened by delboy2028 - 13
Homing Order
#32 opened by Skybound420 - 2
- 0
UBL
#31 opened by delboy2028 - 1
set z-offset in start code
#30 opened by f-wilhelm - 1
[FR] Dual Extruder coords on screen
#29 opened by edgary777 - 2